Passer au contenu de la page Passer à la navigation Passer au pied de page
MOTONEIGE POLARIS

CENTRE D'AIDE

3/12/2021
Patriot Boost RMK Matryx Slash Skag Replacement

Required Tools and Supplies: 

  • 13mm Socket
  • Ratchet
  • Torque Wrench
  • Safety Glasses
  • Nitrile Gloves
  • Shop Rags

Always wear safety glasses and nitrile gloves when servicing your Polaris snowmobile. To remove and replace the skags on your Patriot Boost RMK Matryx Slash, follow these steps. When replacing skags, always replace in pairs and follow all warnings listed in the Owner’s Manual.

1. Ensure the snowmobile is on a flat, level surface.

2. Safely raise the sled so the skis are at least 6 inches off the ground.

3. Use a 13mm socket to remove the three skag nuts and washers inside the ski.

4. Pull the skag down and out of the ski to remove.

5. Inspect the skag for wear or damage, and replace if necessary. Skags should be replaced when they have worn to half their original diameter and should always be replaced in pairs.

6. Align the skag studs to the ski mounting holes, and install the skag.

7. Install the three washers and skag nuts. Torque the nuts to 7 ft-lbs (10 Nm). 

8. Once complete, safely lower the snowmobile to the ground.

For more information, see your authorized Polaris Dealer. To find a dealer near you, use the Dealer Locator.
Maintenance tips, procedures and specifications can be found in your Owner's Manual.
To find diagrams and replacement part numbers, use the online parts catalog.

WALKER EVANS RACING®  is a registered trademark of Walker Evans Enterprises Incorporated