Passer au contenu de la page Passer à la navigation Passer au pied de page


120 INDY Skag Replacement

Required Tools and Supplies:

  • 13mm Deep Socket 
  • Ratchet 
  • Torque Wrench 
  • Safety Glasses 
  • Nitrile Gloves 
  • Shop Rags 

Always wear safety glasses and nitrile gloves when servicing your Polaris snowmobile. To remove and replace the skags on your Polaris 120 INDY, follow these steps. When replacing skags, always replace in pairs and follow all warnings listed in the Owner's Manual

1. Park the snowmobile on a flat, level surface. 

2. Safely raise the sled so the skis are at least 6 inches off the ground. 

3. Remove the two skag nuts and washers inside the ski with a 13mm deep socket. 

4. Pull the skag down and out of the ski to remove. 

5. Inspect the skag for wear or damage and replace if necessary. 

6. Align the skag studs to the ski mounting holes and install the skag. 

7. Install the washer and skag nuts. Torque the nuts to 60 in-lbs (6.77 Nm). 

8. Once complete, safely lower the snowmobile to the ground. 

For more information, see your authorized Polaris Dealer. To find a dealer near you, use the Dealer Locator.
Maintenance tips, procedures and specifications can be found in your Owner's Manual.
To find diagrams and replacement part numbers, use the online parts catalog.