Always wear safety glasses and nitrile gloves when servicing your snowmobile.
To inspect or replace the drive belt on a Polaris AXYS Switchback XCR or INDY XCR snowmobile, follow these steps.
Caution: Do not attempt to remove the drive belt after operating in reverse. The snowmobile must be stopped after forward motion to prevent damage to components during belt removal.
1. Ensure the vehicle is on a flat level surface.
2. Release the rubber strap and turn the two quarter-turn latches on the left side panel.
3. Pull the side panel out and lift up to remove.
4. If needed, rotate the driven clutch counterclockwise 1/4 of a turn to disengage reverse.
5. Set the parking brake.
6. Take note of the drive belt direction of rotation. The belt must be installed in the same direction if reusing.
7. Remove the clutch spreader tool from the panel trim. Spread the panel trim apart as needed to access the driven clutch.
8. Insert the clutch spreader tool into the threaded hole on the driven clutch and turn it clockwise to spread the clutch. Notice: If the tool does not turn readily, rotate the driven clutch an additional 1/4 of a turn counterclockwise and try again.
9. Carefully walk the belt off the driven clutch and remove it from the drive clutch.
10. Inspect the belt for any fraying, hour-glassing, loose cords, missing cogs, abrasions, burns or damage. Replace if needed.
The replacement drive belt is part number 3211215, part number 3211177 or part number 3211165, depending on your vehicle model. Refer to your Owner's Manual for more information.
11. Clean the area around the clutches thoroughly. Warning: Failure to remove ALL debris when replacing the belt could result in vehicle damage, loss of control and severe injury or death.
12. If replacing the belt, the part number on the belt should face outward when installed.
13. Loop the belt over the drive clutch and begin to walk it over the driven clutch sheave.
14. Spin the belt while removing the clutch spreader tool to help seat the belt.
15. Completely remove the clutch spreader tool.
16. Reconnect the side panel trims and reinstall the clutch spreader tool.
17. Reinstall the side panel by inserting the alignment tabs.
18. Secure the rubber strap and latch the two quarter-turn latches on the side panel.
For more information, see your authorized Polaris Dealer. To find a dealer near you, use the Dealer Locator.
Maintenance tips, procedures and specifications can be found in your Owner's Manual.
To find diagrams and replacement part numbers, use the online parts catalog.
YouTube® is a registered trademark of Google LLC
Caliber® is a registered trademark of Caliber, Inc.
Unless noted, trademarks are the property of Polaris Industries Inc.
© 2022 Polaris Industries Inc.