Required Tools and Supplies:
- 13mm Socket
- Torque Wrench
- Safety Glasses
- Nitrile Gloves
- Shop Rags
1. Park the snowmobile on a flat, level surface.
2. Safely raise the sled so the skis are at least 6 inches off the ground.
3. Using a 13mm socket, remove the three skag nuts and washers inside the ski.
4. Pull the skag down and out of the ski to remove.
5. Inspect the skag for wear or damage, and replace if necessary.
6. Align the skag studs to the ski mounting holes and install the skag.
7. Install the three washers and skag nuts. Torque the nuts to 7 ft-lbs (10 Nm).
8. Once complete, safely lower the snowmobile to the ground.
For more information, see your authorized Polaris Dealer. To find a dealer near you, use the Dealer Locator.
Maintenance tips, procedures and specifications can be found in your Owner's Manual.
To find diagrams and replacement part numbers, use the online parts catalog.