Skip to content Skip to navigation Skip to footer
POLARIS SNOWMOBILE

HELP CENTER

2020-06-05
Adjusting Your Snowmobile Headlights

Snowmobile headlight diagram

The vertical aim of your Polaris snowmobile's headlights can be tested using the following procedure:

1. In a well-ventilated area, position the snowmobile on a level surface with the headlight approximately 25 feet (7.6 m) from a wall (1), as shown in the above diagram.

2. Place the rider or the approximate weight of the rider on the seat or tunnel floorboards.

3. Measure the distance from the floor to the center of the headlight and make a mark on the wall at the same height.

4. Start the engine. Move the headlight switch to high beam.

5. Observe the headlight aim on the wall. The most intense part of the headlight beam should be 2 inches (5 cm) (2) below the mark on the wall.

6. If an adjustment is necessary, locate the headlight adjuster. It will be found in one of two locations.

  • The first headlight adjuster location is below the headlight and can be accessed through the left side panel, as shown in the two photos below.

    Snowmobile headlight adjuster knob
    Snowmobile headlight adjuster knob closeup
     
  • Turn the adjuster knob clockwise to lower the beam. Turn it counter-clockwise to raise the beam.
  • On other models, the headlight adjuster can be found to the left of the instrument cluster, as shown in the diagram below.

    Snowmobile headlight adjuster knob diagram
     
  • Move the adjuster (1) to the left to adjust the headlight beam upward. Move the adjuster to the right to adjust the beam downward.

For more maintenance procedures, consult your Owner's Manual
To find replacement parts for your snowmobile, view the online parts catalog. For more on using the parts catalog, see How to Find Snowmobile Parts.
To find a Polaris Dealer near you, use the Dealer Locator.

Keyword(s) headlight , adjust , adjusting , aim , change , changing , light